NEW! - Spray Foam Insulation and Termites: This document addresses questions pertaining to inspection for, and treatment of, potential termite infestations in buildings using SPF Insulation. It provides basic information about terminte identification, inspection and treatments methods as well as discusses the importance of air-sealing and insulation of critical areas using SPF. It also present code-compliant solutions to address these concerns.
SPF Gun Cleaners: Provides an overview of gun cleaning solvents and safe methods for basic spray gun cleaning. SPFA's gun cleaner tech tip is a short and concise outline of how many spray foam contractors clean their spray foam gun and its associated parts plus key safety items to consider.
SPF - Exotherm vs. Thickness: When curing, SPF generates exothermic temperatures. When applied at excessive pass thickness, these temperatures can result in poor quality foam and, in some cases, can cause scorching or even self-ignition of the foam. This new Tech Tip provides some important information about the cause and prevention of high exothermic temperatures during application.
Maintaining Proper SPF Material Temperatures: If not properly stored within the manufacturer's suggested temperature ranges, foam chemicals can degrade and change viscosity, making them difficult if not impossible to apply properly. This new Tech Tip provides some general guidance on the proper storage and use of SPF chemicals to assure optimum shelf life and application during summer and winter months.
Picture Framing: Picture framing techniques for medium-density foam. It details the procedure used to minimize cracks and voids when applying MD foam on framed cavity walls, roofs and floors.
Cold Weather Roof Coating Recommendations: When roof coatings are applied at temperatures below about 55oF (13oC), several challenges are encountered by the applicator. This new Tech Tip provides some important information about how to safely handle and apply typical roof coatings, as well as recommendations for storage, pumping, spraying and application techniques for coatings under cold weather conditions.
Combustion Appliances: Before applying SPF insulation in an attic or crawl space it is important to determine if there are any appliances present, such as a water heater or a furnace, that are open-combustion and require a source of combustion air.
NEW! - Spraying Polyurethane Foam to CPVC Pipes: Both closed-cell and open-cell SPF may be applied to CPVC piping without damage caused by the SPF's exotherm (heat of reaction).